Siemens SINUMERIK 840D sl Function Manual page 145

03/2013
Function
Weekly
Monthly
Duration of the interval
Last execution
Undefined
- On the
Each trigger can be assigned a label, which determines its behavior at the central
start date for maintenance.
See also Section: Editing the master data of a machine and the general description
of the trigger in Section: Setting up functions.
Options:
•
If a label has been set and a start date, which has not yet been reached, has
been configured in the overview of the control monitors, the trigger will not be
initiated.
•
If the date has been reached or is in the past, the interval starts and a trigger
is initiated at the end of the interval.
•
If a start date has not been configured, or the label has not been set, the
trigger will be initiated at the end of the interval according to the conditions set
for it.
Notice
The starting time and start date are not the time of the first trigger, but the start of
the interval at the end of which the trigger takes place.
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
Description
Enter a cycle 'n' in
- Weeks,
by selecting a day of the week from Monday to
Sunday.
Enter a cycle 'n' in
- Months.
Either by selecting the
- first
- second
- third or
- fourth
day of the week from Monday to Sunday in the
month
- OR -
one day from 1 to 31 in the month (then, without
a weekday).
There is no restriction pre-selected regarding a
last initiation.
If you deselect "Undefined", you need to select a
date for the last execution.
You can only make an entry if undefined is
deselected for the last execution.
The can only specify a date for the last
execution via the calendar selection function.
3 Setting up functions
3.4 Fault services
Type
DISPLAY
INPUT
SELECTION
(1 to 99 999
minutes or
hours)
DISPLAY
INPUT
SELECTION
(1 to 99 999
minutes or
hours)
DISPLAY
SELECTION
(Toggle)
DISPLAY
SELECTION
3-145