Siemens SINUMERIK 840D sl Function Manual page 220

4 Organizational tasks
4.1 Maintenance
Fig. 4-3: Executing a maintenance job on the control
Function
Master data
Job no., job
name, date
(due)
Status
4-220
Description
Display your own data from the machine master
data. Where a job is concerned, this may vary
depending on the view used for visualization: i.e.
whether it is viewed from the perspective of any
given partner, or, in the case of the maintenance
job list, your own point of view.
Unique, consecutive numbers for maintenance
jobs which are automatically generated by the
system in order to avoid misunderstandings in
communication
Name of the maintenance schedule which the
user has allocated during configuration
Execution time for the maintenance job,
calculated by the system according to the basic
settings configured by the user
Indicates the status of the job. The status can be
changed by the user at this point.
Opening the job should indicate that the
maintenance procedures required in the job have
already been carried out.
Closing the maintenance job corresponds to
acknowledging it; here it can be determined
whether the maintenance procedures were
performed successfully.
Important:
Even when the display has a particular status, it
is not actually set to this. In each case, the status
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
© Siemens AG 2006-2013 All Rights Reserved
03/2013
Type
DISPLAY
DISPLAY
SELECTION