Siemens SINUMERIK 840D sl Function Manual page 178

3 Setting up functions
3.4 Fault Services
Function
Remaining
performance
Configure PLC
settings
"Icons" tab
PLC area
Absolute address
Absolute address
Comment
Data type
Add icon
Absolute address
3-178
Description
Note:
If the remaining memory is insufficient for the current
definition of a trace, you can save the control monitor
inactively in the system. To make it possible to
activate it, you must free up memory by deactivating
one or more of the control monitors.
Shows how much performance is left in the PLC
cycle time for PLC triggers and PLC conditions.
See also Section: Fault services
Since data blocks must be used in the PLC for the
configuration of PLC traces, these must be specified
in the PLC settings for SINUMERIK Integrate. If this
has not been done in the PLC settings or needs to be
checked again, it is possible to branch directly from
here for this purpose.
Shows the PLC variables with absolute addresses
(not symbolic addresses), which are to be recorded
in the trace, or for which additional programming can
be carried out.
The following selection can be made:
All: All PLC variables
E: Only PLC input variables
A: Only PLC output variables
M: Only flags
Z: Only counters
T: Only timers
DBs: Only data blocks
Note:
The PLC variables to be recorded are selected in the
same way as PLC triggers/conditions.
See also Section: Machine trigger on "PLC variable"
Display of the absolute address.
Displays a comment for the absolute address.
Displays the data type.
Entry of the address of a PLC variable via STEP 7
syntax.
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
Type
DISPLAY
ACTION
TAB DISPLAY
INPUT
S7 syntax
S7 formats
(max. 40
characters for
naming, all
characters are
permissible)
DISPLAY
DISPLAY
DISPLAY
INPUT
DISPLAY
© Siemens AG 2006-2013 All Rights Reserved
03/2013