Parameters/Address Space; Configuring - Siemens SIMATIC ET 200SP Equipment Manual

Parameters/address space

4.1

Configuring

Introduction
You configure and assign the parameters of the communications module with STEP 7
(TIA Portal).
System environment
The communications module can be used in the following system environments:
Applications Components required
Centralized operation
•
with a CPU 151xSP
•
Distributed operation
•
with an S7-1500 CPU
•
•
Distributed operation
•
with an S7-300/400
CPU
•
•
Distributed operation
•
in a third-party sys-
•
tem
1
•
Information on using the communications module in a third-party system is available in the
1
programming and operating manual CM PtP operation with PROFINET controller
(http://support.automation.siemens.com/WW/view/en/59062563).
26
ET 200SP automation system
CM PtP
S7-1500 automation system
ET 200SP distributed I/O sys-
tem
CM PtP
S7-300/400 automation sys-
tem
ET 200SP distributed I/O sys-
tem
CM PtP
Third-party automation system
ET 200SP distributed I/O sys-
tem
CM PtP
Configuration software
STEP 7 (TIA Portal):
Device configuration and pa-
rameter setting with hardware
configuration
STEP 7 (TIA Portal):
Device configuration and pa-
rameter setting with -
configuration
STEP 7 (TIA Portal):
Device configuration and pa-
rameter setting with hardware
configuration
STEP 7:
Device configuration and pa-
rameter setting with GSD file
Third-party configuration
software:
Device configuration and pa-
rameter setting with GSD file
CM PtP communications module (6ES7137-6AA01-0BA0)
Equipment Manual, 03/2021, A5E03790792-01
4
In the user program
Instruction libraries PtP Com-
munication, USS Communica-
tion and MODBUS (RTU)
(Page 35)
Instruction libraries PtP Com-
munication, USS Communica-
tion and MODBUS (RTU) with
the entry ID 75226762
(https://support.industry.sieme
ns.com/cs/ww/en/view/75226
762) in the Siemens Industry
Online Support
Instructions for control and
parameter assignment accord-
ing to the programming man-
ual
1