03/2013
3.2.3 Universal axis test
Parameter description
Parameters for conducting a universal axis test:
Function
Name
Channel
Axis
Start point
Fig. 3-14: Universal axis test on the operator panel
Fig. 3-15: Measurement series for a universal axis test at the PC
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3.2 Configuring measurements and measurement series
Description
Name of the measurement series
(measurements do not have a name).
Selection of the required channel: The channel
defines the possible machine axes in the "Axis"
selection list.
Selection from the possible machine axes that
can be programmed in the selected channel.
The axis position at which the various
movements of the measurement begin.
The position value is never lower than this value
during measurement.
3 Setting up functions
Type
INPUT
SELECTION
SELECTION
INPUT
3-107