Enable Web; Disable Web - D-Link DGS-1100-06/ME Cli Reference Manual

enable web

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable HTTP and configure the TCP port number to listen for Telnet requests:

disable web

Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
System up time
System Time
System hardware version
System firmware version
System boot version
System Protocol version
System serial number
MAC Address
SNMP Status
Port Mirroring
802.1X Status
Storm Control
802.1Q Management VLAN
Safeguard Engine
IGMP Snooping
DGS-1100-06/ME:5#
To enable the HTTP-based management software on the Switch.
enable web {<tcp_port_number 1-65535>}
The enable web command enables the Web-based management
software on the Switch. The user can specify the TCP port number
the Switch uses to listen for Telnet requests.
<tcp_port_number 1-65535> − The TCP port number. TCP ports are
numbered between 1 and 65535. The 'well-known' port for the Web-
based management software is 80.
Only Administrator or operator-level users can issue this command.
DGS-1100-06/ME:5# enable web
Command: enable web
Success.
DGS-1100-06/ME:5#
To disable the HTTP-based management software on the Switch.
disable web
The disable web command disables the Web-based management
software on the Switch.
None.
Only Administrator or operator-level users can issue this command.
: 0 days, 0 hrs, 20 min, 28 secs
: 01/01/2012 00:20:30
: A1
: 1.00.008
: 1.00.000
: 2.001.004
: 1MB1733K0000A
: 00-AE-B7-21-22-62
: Enabled
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled
: Disabled
13