Show Ethernet_Oam Ports (Configuration) - D-Link DGS-1100-06/ME Cli Reference Manual

Parameters
Restrictions
Example usage:
To show OAM control and status information on port 1:
DGS-1100-06/ME:5# show ethernet_oam ports 1 status
Command: show ethernet_oam ports 1 status
Port 1
Local Client
-----------------------------------------------------------
OAM
Mode
Max OAMPDU
Remote Loopback
Unidirection
Link Monitoring
Variable Request
PDU Revision
Operation Status
Loopback Status
DGS-1100-06/ME:5#

show ethernet_oam ports (configuration)

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
mode.
Initiating Loopback – The local port has sent the start remote
loopback request to the peer and is waiting for response.
Remote Loopback – This indicates that both the local and
remote ports entered the loopback mode. Any non-OAM packet
received in the local port will be dropped.
Local Loopback – This indicates that both the local and remote
ports entered the loopback mode. The local port is doing the
loopback. Any non-OAM packets received on the port will be sent
back to the same port.
Terminate Loopback - The port is stopping loopback on the port.
[all | <portlist>] – Specifies a range of ports or all ports to display
status.
None.
Used to display Ethernet OAM configuration per port.
show ethernet_oam ports [all | <portlist>] configuration
The show ethernet_oam ports command is used to view Ethernet
OAM configurations for ports.
[all | <portlist>] – Specifies a range of ports or all ports to display
status.
None.
: Enabled
: Passive
: 1518 Bytes
: Support
: Not Supported
: Support
: Support
: 0
: Disabled
: No Loopback
257