Show Time - D-Link DGS-1100-06/ME Cli Reference Manual

Restrictions
Example usage:
To configure daylight savings time on the Switch to run from the 2
October at 3:30 PM and add 30 minutes at the onset of DST:
DGS-1100-06/ME:5#config dst annual s_date 2 s_mth 4 s_time 3 end_date 2
e_mth 10 e_time 3 offset 30
Command: config dst annual s_date 2 s_mth 4 s_time 3 end_date 2 e_mth 10
e_time 3 offset 30
Success!
DGS-1100-06/ME:5#

show time

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the time cuurently set on the Switch's System clock:
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
 s_date <start_date 1-31> - The day of the month to begin
DST, expressed numerically.
 s_mth <start_mth 1-12> - The month of the year to begin
DST, expressed numerically.
 s_time <start_time> - The time of day to begin DST in hours
and minutes, expressed using a 24-hour clock.
 end_date <int 1-31> - The day of the month to end DST,
expressed numerically.
 e_mth <end_mth 1-12> - The month of the year to end DST,
expressed numerically.
 e_time<end_time> - The time of day to end DST, in hours
and minutes, expressed using a 24-hour clock.
offset [30 | 60 | 90 | 120] – Indicates the number of minutes to add
during the summertime. The possible offset times are 30, 60, 90,
and 120. The default value is 60.
Only Administrator or operator-level users can issue this command.
To display the current time settings and status.
show time
The show time command displays the system time and date
configuration, as well as displays the current system time.
None.
None.
nd
Tuesday in April at 3 PM until the 2
196
nd
Wednesday in