Table of Contents
Advertisement
Dakota Ultrasonics
31) Press the
POSITIVE or NEGATIVE polarity options.
32) Press the
33) Press the
times to tab left until the MATL menu is highlighted and displaying the
submenu items.
Note: In order for the MiniMax to display the correct measurement value
during calibration, the material velocity and temperature coefficient must be set
to the same values as in the calibration section, and the stress factor set to
1.000.
34) Press the
menu items until VELOCITY is highlighted.
35) Press the
36) Press the
value.
37) Press the
locations.
38) Repeat steps 34 & 35 until the VELOCITY value is correctly displayed.
and
arrow keys multiple times to scroll AUTO,
key once to leave the Two Point Zero list.
key multiple times to tab right and the
and
arrow keys multiple times to scroll through the sub
key to display the Digits Edit Box.
and
arrow keys multiple times to scroll the highlighted
and
arrow keys multiple times to scroll the digit
80
key multiple
Advertisement
Table of Contents
