DAKOTA ULTRASONICS MiniMax v2.0 Operation Manual page 83

7) Press the key to display the Digits Edit Box.
8) Press the
value.
9) Press the and
locations.
10) Repeat steps 8 & 9 until the PHY LEN 1 value is correctly displayed.
11) Press the
entering the PHY LEN 1.
12) Press the
Zero list until PHY LEN 2 is highlighted.
Note: PHY LEN 2 is the actual physical length of the second calibration
standard. If the glass block is being used, the 3" side should be used for PHY
LEN 2.
13) Press the
14) Press the
value.
15) Press the
locations.
and arrow keys multiple times to scroll the highlighted
arrow keys multiple times to scroll the digit
key to return to the Two Point Zero list, or
and arrow keys multiple to scroll through the Two Point
key to display the Digits Edit Box.
and arrow keys multiple times to scroll the highlighted
and arrow keys multiple times to scroll the digit
MiniMax Bolt Tension Monitor
77
to cancel