CHAPTER THREE
QUICK START GUIDE
3.1 Overview
This section demonstrates the basic procedures for setting up and measuring bolts
using the MiniMax. More in depth explanations pertaining to the individual functions
and features can be found in the chapters that follow.
Here we go!
3.2 Getting the MiniMax ready
In order to get the MiniMax ready for operation; the following connections must
be made:
1) Remove the MiniMax from the carrying case.
2) Connect the transducer cable to the transducer and plug it into the MiniMax.
3) If a temperature sensor is being used, connect the sensor to the MiniMax.
3.3 Setting up the MiniMax
Please Read: In this section the MiniMax will be setup in its simplest form.
Remember this is only a quick start guide to get the user up and measuring bolts.
Before we setup the gauge to measure basic elongation, the following assumptions
must be made: A preset material type will be used. The user will not be re-measuring
the fasteners at a later date to monitor relaxation of the joint over time. This
eliminates the need for an instrument zero/calibration. All these assumptions will be
answered and explained in detail in the chapters that follow.
Making all the connections
Selecting Default Setup
8