Table of Contents
Advertisement
Note: Enter the known ultrasonic length of the bolt that was documented and
stored in the previous section. We will consider this ultrasonic length to be the
actual physical length from this point forward. Reminder: It was stored in the
first column of the probe zero group.
8) Press the
value.
9) Press the
and
locations.
10) Repeat steps 8 & 9 until the PHY LEN 1 value is correctly displayed.
11) Press the
entering the PHY LEN 1 value.
12) Press the
Point Zero List Items until VELOCITY is highlighted.
13) Press the
Note: Enter the velocity value of the bolt that was documented in the previous
section. Reminder: The value was written down and scribed on the side of the
bolt, and is the velocity used for the probe zero bolt.
and
arrow keys multiple times to scroll the highlighted
arrow keys multiple times to scroll the digit
key to return to the One Point Zero List, or
and
arrow keys multiple times to scroll through the One
key to display the Digits Edit Box.
MiniMax Bolt Tension Monitor
69
to cancel
Advertisement
Table of Contents
