Table of Contents
Advertisement
Dakota Ultrasonics
Starting delay
The starting DELAY, or starting length, is the value displayed on the bottom lower left
side of the display in both RF and RECT (Rectified) views.
Note: Once the range is set, it will remain the same for all the views respectively.
The procedures to adjust the Delay are outlined below:
Adjusting the Delay using the Hot Menus
1) Press the
key multiple times to move right and the
until the DELAY cell is highlighted.
2) Press the
value.
3) Alternatively, press the
4) Press the
value.
5) Press the
locations.
6) Repeat steps 4 & 5 until the DELAY value is correctly displayed.
7)
Press the
entering the DELAY.
The user can also access and adjust the delay from the tabbed menus. However,
this method is more tedious than making the adjustments using the Hot Menus. The
procedure using the tabbed menus is outlined below:
Adjusting the Delay using the Tabbed Menus
key once to activate measure menu items. Press the
and
arrow keys multiple times to scroll the highlighted
key to display the Digits Edit Box.
and
arrow keys multiple times to scroll the highlighted
and
arrow keys multiple times to scroll the digit
key to return to the measurement screen, or
key multiple times to move left,
130
to cancel
Advertisement
Table of Contents
