Table of Contents
Advertisement
4.22 Top & Bottom End Caps
The top & bottom end panels are where all connections are made to the MiniMax.
The diagram above shows the layout and description of the connectors:
Transducer Connector
Refer to Diagram: The transducer connector is a board mounted and shielded
LEMO "00".
Temperature Sensor Connector
Refer to Diagram: The temperature sensor connector is a Shielded custom 5 pin
Lemo "1".
Battery Cover (backup)
Refer to Diagram: The battery cover is the large round disk shown in the diagram.
Simply remove the cover when replacing the batteries (3AA cells).
Important: Be sure to follow the polarity labels located on the back label of the
MiniMax. Note: Rechargeable batteries can be used however they must be
recharged outside of the unit in a stand-alone battery charger.
USB Type B Connector
Refer to Diagram: The USB-C connector, located on the bottom end cap, is a mini
type C female connector. It is designed to connect directly from the MiniMax to a
standard USB type A port on a PC. It can be used as line power when connected to
a the USB PC port. The battery icon will display the line power is activated. It can
also be powered by a standard cell phone adapter into a power outlet. The line
power will not provide power to rechargeable batteries. The cable supplied with the
MiniMax is a USB type C to a USB type A (pt# N-003-0330).
Note: This connector is also used to upgrade the MiniMax with the latest version of
firmware.
37
Advertisement
Table of Contents
