Audio Dubbing - Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual

Audio dubbing

You can dub additional sound on your recorded
tape by specifying starting and ending points.
The original sound will not be erased.
Use the Remote Commander for this operation.
Do not connect the video (yellow) plug.
: Signal flow /
Adding audio on a recorded
tape
(1) Prepare the power supply and insert your
recorded tape into your VCR.
(2) Set the POWER switch to ON.
(3) Locate the recording start point by pressing
H. Then press X at the point where you
want to start recording to set your VCR to the
playback pause mode.
(4) Press AUDIO DUB on the Remote
Commander. The green
appears on the screen.
(5) Press X and start playing back the audio you
want to record at the same time.
The additional audio is recorded in stereo 2
(ST2) during playback. While recording new
sound, the red
(6) Press x at the point where you want to stop
recording.
AUDIO/VIDEO
INPUT
X indicator
appears on the screen.
AUDIO L
A/V connecting cable (supplied)
A/V converting cable (supplied)/
(1)
(2)
(3)
H
(4)
(5)
(6)
Audio equipment
LINE OUT
L R
AUDIO R
X
X
x
X
93