Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual page 153

Viewing images recorded on
"Memory Stick"s on your
computer
Note
You cannot install the USB driver if a "Memory
Stick" is not in your VCR.
Be sure to insert a "Memory Stick" into your
VCR before installing the USB driver.
Image data cannot be transferred by
the USB connection
The USB driver has been registered incorrectly as
your computer was connected to your VCR
before installation of the USB driver was
completed. Perform the following procedure to
correctly install the USB driver.
Step 1 Uninstall the incorrect USB driver
1 Turn on the power and allow Windows to
load.
2 Connect the USB jack on your computer to
the (USB) jack on your VCR using the USB
cable supplied with your VCR.
3 Insert a "Memory Stick" into your VCR, and
set the POWER switch to ON.
4 Open your computer's "Device Manager".
Windows 2000 Professional:
Open "My Computer" t "Control Panel"
t"System" t "Hardware" tab, and click
the "Device Manager" button.
Other OS:
Select "My Computer" t "Control Panel"
t "System", and click "Device Manager".
5 Select "Other devices".
Select the device prefixed with the (?) mark
and delete.
Ex: (?)Sony Handycam
6 Set the POWER switch to OFF (CHG), and
then disconnect the USB cable.
7 Restart your computer.
Step 2 Install the USB driver on the CD-ROM
Perform the entire procedure listed in "Installing
the USB driver" on page 151.
1
2
3
4
t
5
6
7
t
t t
t
153