Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual page 109

Changing the menu settings
Icon/item Mode
A/VtDV OUT z OFF
NTSC PB
z ON PAL TV
(GV-D1000E
only)
LCD B. L.
z BRT NORMAL
LCD COLOR
(GV-D1000)
LCD COLOUR
(GV-D1000E)
STILL QLTY z FINE
MOVIE SET
IMAGESIZE z 320
z AUTO
REMAIN
PRINT MARK
z OFF
Note on NTSC PB (GV-D1000E only)
When you play back a tape on a Multi System TV, select the best mode while viewing the picture on
the TV.
Note on LCD B.L.
When you select BRIGHT, battery life is reduced by about 10 percent during recording.
Even if you adjust LCD B.L., LCD COLOR (LCD COLOUR).
The recorded picture will not be affected.
Meaning
To output digital images and sound in analog format using your
VCR.
ON To output analog images and sound in digital format using your
VCR (p. 88).
To play back a tape recorded in the NTSC colour system on a PAL
system TV
NTSC 4.43 To play back a tape recorded in the NTSC colour system on a TV
with the NTSC 4.43 mode
To set the brightness on the LCD screen to normal.
BRIGHT To brighten the LCD screen.
—— To adjust the color on the LCD screen, turn the SEL/PUSH EXEC
dial.
To get Low-
intensity
To record still images in the fine image quality mode (p. 122).
STANDARD
To record still images in the standard image quality mode.
240 To record moving pictures in 320 240 size (p. 124).
160 112 To record moving pictures in 160 112 size.
To display the remaining capacity of the "Memory Stick" in the
following cases:
• For five seconds after inserting a "Memory Stick" into your VCR
• When the capacity of the "Memory Stick" is less than one minute
while the display shows.
• For five seconds after completing a moving picture recording
ON
To always display the remaining capacity of the "Memory Stick."
ON To write a print mark on the recorded still images you want to print
out later (p. 172).
To cancel print marks on still images.
To get High-
intensity
(Continued on the following page)
109