Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual page 152

Viewing images recorded on
"Memory Stick"s on your
computer
(2) Insert the supplied CD-ROM in the CD-ROM
drive of your computer. The application
software screen appears.
(3) Set the cursor on "USB Driver" and click.
USB driver installation starts.
(4) Follow the on-screen messages to install the
USB driver.
(5) Restart your computer.
(6) Connect the AC power adaptor and set the
USB MODE switch to
STICK).
The default setting is VCR.
(7) Set the POWER switch to ON, and insert a
"Memory Stick" into your VCR.
(8) Connect the
the USB connector on your computer using
the supplied USB cable.
USB MODE appears on the screen of your
VCR. Your computer recognizes the VCR,
and the Windows Add Hardware Wizard
starts.
(9) Follow the on-screen messages to have the
Add Hardware Wizard recognize the
hardware. The Add Hardware Wizard starts
twice because two different USB drivers are
installed. Be sure to allow the installation to
complete without interrupting it.
152
(MEMORY
(USB) jack on your VCR with
USB connector/
USB cable (supplied)/
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(USB) jack/
Push into the end/