Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual page 91

Inserting a scene from the other
VCR – Insert Editing
(1) Set the POWER switch to ON on your
(recording) VCR.
(2) On the other (playback) VCR, locate just
before the insert start point [a], then press
PAUSE to set the other (playback) VCR to the
playback pause mode.
(3) On your (recording) VCR, locate the insert
end point [c] by pressing m or M. Then
press X to set your (recording) VCR to the
playback pause mode.
(4) Press ZERO SET MEMORY on the Remote
Commander. The ZERO SET MEMORY
indicator flashes and the end point of the
insert is stored in memory.
The counter shows "0:00:00".
(5) On your (recording) VCR, locate the insert
start point [b] by pressing m, then press
z REC and the button on its right
simultaneously then immediately press X to
set your (recording) VCR to the recording
pause mode.
(6) First press PAUSE on the other (playback)
VCR, and after a few seconds press X on
your (recording) VCR to start inserting the
new scene.
Inserting automatically stops near the zero
point on the tape counter. Your (recording)
VCR automatically stops. The end point [c]
of the insert stored in memory is canceled.
5
REC
(1)
(2)
(3)
m
X
(4)
(5)
[b]
X
(6)
X
4
ZERO SET
MEMORY
[a]
[c]
M
m
z
0:00:00
ZERO SET
MEMORY
91