Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual page 81

Dubbing only desired scenes
– Digital program editing (on
tapes)
Step 3: Adjusting the
synchronicity of the other
(recording) VCR
You can adjust the synchronicity of your
(playback) VCR and the other (recording) VCR.
First, eject the tape from your (playback) VCR.
Have a pen and paper ready for notes.
(1) Set the POWER switch to ON on your
(playback) VCR.
(2) Insert a blank tape (or a tape you want to
record over) into the other (recording) VCR,
then set to recording pause.
When you select i.LINK in CONTROL, you
do not need to set to recording pause.
(3) Turn the SEL/PUSH EXEC dial to select
ADJ TEST, then press the dial.
(4) Turn the SEL/PUSH EXEC dial to select
EXECUTE, then press the dial.
IN and OUT are recorded on the image five
times each to calculate the numerical values
for adjusting the synchronicity.
The EXECUTING indicator flashes on the
screen. When finished, the indicator
changes to COMPLETE.
(5) Rewind the tape in the other (recording)
VCR, then start slow playback.
Take a note of the opening numerical value
of each IN and the closing numerical value
of each OUT.
(6) Calculate the average of all the opening
numerical values of each IN, and the
average of all the closing numerical values
of each OUT.
(7) Turn the SEL/PUSH EXEC dial to select
"CUT-IN", then press the dial.
(8) Turn the SEL/PUSH EXEC dial to select the
average numerical value of IN, then press
the dial.
The calculated start position for recording is
set.
(9) Turn the SEL/PUSH EXEC dial to select
"CUT-OUT", then press the dial.
(10) Turn the SEL/PUSH EXEC dial to select the
average numerical value of OUT, then press
the dial.
The calculated stop position for recording is
set.
(11) Turn the SEL/PUSH EXEC dial to select
RETURN, then press the dial.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
81