Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual page 94

Audio dubbing
Notes on audio dubbing
•Additional audio cannot be recorded on a tape
already recorded in the 16-bit mode (32 kHz,
44.1 kHz or 48 kHz).
•Additional audio cannot be recorded on a tape
already recorded in the LP mode.
•You cannot add audio with the DV jack.
•You cannot add audio on the blank portion of
the tape.
If an i.LINK cable (DV connecting cable)
(optional) is connected to your VCR
You cannot add sound to a recorded tape.
To record additional sound with the
microphone (optional)
Connect the microphone (optional) to the
microphone jack of audio equipment.
We recommend that you add additional audio
on a tape recorded with your VCR
If you dub additional sound on a tape recorded
with another VCR (including other
GV-D1000/D1000E), the sound quality may
deteriorate.
If you set the write-protect tab of the tape to
lock
You cannot record on a tape. Slide the write-protect
tab to release the write protection.
To add new sound more precisely
Press ZERO SET MEMORY on the Remote
Commander at the point where you want to stop
recording later in the playback mode.
Carry out steps 3 to 5. Recording automatically
stops at the point where ZERO SET MEMORY
was pressed.
When playback pause mode lasts for five
minutes
Your VCR automatically enters the stop mode.
94