Sony GV-D1000 Operating Instructions (primary manual) Operating Instructions Manual page 72

Dubbing only desired scenes
– Digital program editing (on
tapes)
Notes
•When you connect with the i.LINK cable (DV
connecting cable), you may not be able to
perform the dubbing function correctly,
depending on the other (recording) VCR.
Set CONTROL to IR in the menu settings of
your (playback) VCR.
•When editing digital video on tapes, the
operation signals cannot be sent with
Step 1: Connecting the other
(recording) VCR
You can connect either the A/V connecting cable
or the i.LINK cable (DV connecting cable).
When you use the A/V connecting cable, connect
the devices as illustrated on page 67.
When you use the i.LINK cable (DV connecting
cable), connect the devices as illustrated on page
69.
If you connect using the i.LINK cable (DV
connecting cable)
With digital-to-digital connection, video and
audio signals are transmitted in digital form for
high-quality editing.
Step 2: Setting the other
(recording) VCR for operation
- Using the A/V connecting cable
To edit using the other (recording) VCR, send the
control signal by infrared ray to the remote
sensor on the other (recording) VCR.
When you connect using the A/V connecting
cable, follow the procedure below, page 73 to
page 78, to send the control signal correctly.
72
LANC.