Operating Your Fireplace; Fireplace Control Devices; How To Turn Your Fireplace On; How To Turn Your Fireplace Off (Including Pilot) - Valor H6 Series Installation And Owner's Manual

Fireplace Control Devices

There are two ways to control
your fi replace.
1. Thermostatic Remote Control
can be programmed to function
automatically—see page 8;
2. Wall Switch turns fi re on, off
controls fl ame height—see page 12.

How to Turn Your Fireplace ON

Press and hold button(s) until a short beep confi rms the
start sequence has begun; release buttons.
Continuing beeps confi rm the ignition is in process.
When the pilot is lit, the gas fl ows—see Using the
Remote Control section for more information.

How to Turn Your Fireplace OFF (including pilot)

Remote control
handset
Press and hold the OFF button for a second (either on
the handset or the wall switch).
Remote control
handset
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
In the unlikely event that you cannot turn off your
fi replace with the remote control handset, use the
wall switch; if the wall switch malfunctions and will not
turn off the fi replace, wait 6 hours and the fi replace
will automatically go to pilot. You can then access the
controls inside your fi replace.
Alternately, turn off gas supply. In all cases, call your
dealer for service assistance.

Operating Your Fireplace

Thermostatic
Remote
Wall Switch
Control
and
Wall Switch
Wall Switch
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
ON: parallel to pipe OFF:
perpendicular
to pipe
You can use one of the two following methods to
ensure that your fi replace will not turn on when you
WARNING
!
RISKS OF SEVERE BURNS! SURFACES OF
THE FIREPLACE ARE VERY HOT DURING
OPERATION! Ensure fi replace has cooled off
before accessing controls.
don't want it on.
• On gas valve, turn dial from ON position to MAN
position as shown. Turning dial to MAN will ensures
Fireplace
Receiver Gas valve
Receiver and gas valve located on bottom of fi replace
under removable panel. Battery holder located next to
wall switch.
that main burner
cannot come
on. The pilot will
remain on if lit.
• Alternately,
remove all
batteries from
the battery holder next to the wall switch as well as
the battery from the handset.
Automatic Shut-Off (in certain conditions)
Your fi replace's remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See Using the Remote Control
section for a description of this feature.
OWNER'S
INFORMATION
Battery
holder
& wall
switch
ON
Gas valve
7