Valor H6 Series Installation And Owner's Manual page 55

5. Place the right cross log inserting its pin in the hole
at the front center of the platform. Rest its narrow
fl at edge about 1 inch in front of the rear edge of the
burner's cavity. There should be an air space under
the log; move the shale pieces if necessary.
air space under the log—move
the shale if necessary
6. Place the right log inserting its pin on the front right
hole on the burner platform; the block in the middle
goes to the notch on the right cross log and the
other end rests on the fl at space on the rear log.
Installation
7. Add some shale to cover the edge of the cavity in
the burner platform.
Pebbles
Place the pebbles on the shale and platform as
suggested below.
NOTE: Ensure the area within and in front of the pilot
shield is not blocked by shale particles or rock.
CHOKING HAZARD! Ensure that the fi replace
area is clear of shale particles as these could be
ingested by small children. Vacuum area after
installation.
QUALIFIED
INSTALLER
pilot area
pilot area
WARNING
!
55