Operating Your Fireplace; Fireplace Control Devices - Valor 1700KP Homeowner's Manual

Operating your fireplace

Fireplace control devices

There are two ways to control your fi replace.
1. Thermostatic Remote Control turns fi re and
lights ON and OFF, controls fl ame height and can
be programmed to function automatically.
2. Wall Switch turns fi re ON and OFF, and controls
fl ame height.
Remote Control
Turn your fi replace ON
WARNING
STOP IF YOU SMELL GAS! DO NOT LIGHT!
See cover page immediately!
Press and hold:
- button on remote, or
- ON-OFF button on wall switch
until a short beep confi rms the start sequence has
begun; release button.
The fi replace beeps twice to confi rm the ignition is in
process. The pilot lights up, followed by the fi replace.
If you are using the handset, it displays a pilot fl ame
symbol ( ) during the ignition sequence.
If you need to light up the pilot manually, see the
Fireplace and Lighting Information card attached to
the fi replace - see page 7 to learn how to access it.
Also, a copy of this card is reproduced in Appendix A
of the Installation Manual.
Wall Switch
Turn your fi replace OFF (including pilot)
Press and hold:
- button on remote, or
- ON-OFF button on wall switch
If the fl ames or pilot are on, they will go out and you
will hear the valve motor wind down. You will hear
a clunk and a beep indicating that the valve has
received the signal from the remote control.
In the unlikely event that you cannot turn off your
fi replace with the remote control handset, use the
wall switch. If the wall switch malfunctions and
will not turn off the fi replace, wait 3 hours and the
fi replace will automatically go to pilot. You can then
access the controls inside your fi replace, once it has
cooled.
WARNING
Risk of severe burns! Surface of the
fi replace are very hot during operation!
Ensure fi replace has cooled off before
accessing control.
Alternatively, you may turn off the house gas supply.
In all cases, call your dealer for service assistance.
ON:
parallel
to pipe
To use additional functions of your Remote
Control such as temperature or program
settings, see "Appendix A-Remote Control
Operation" on page 22 of this manual or
visit valorfi replaces.com/remotes
OFF:
perpendicular
to pipe
9