Refi T Window - Valor H6 Series Installation And Owner's Manual

QUALIFIED
INSTALLER
Refi t Window
1. To refi t the window, place it in its bottom support
railing. Ensure there is no glass or vermiculite
particles in the bottom railing.
Bottom
support railing
2. Push the top of
the window frame
against the fi rebox.
3. While you hold it, pull the side levers back into the
window brackets on each side.
3
62
Installation
Window frame
Section Views
4. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox.
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
DANGER
!
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
WARNING
!
Failure to install window correctly can affect
the performance of the fireplace, damage
components, cause overheating resulting in
dangerous conditions. Damage caused by
incorrect window installation is not covered
by the Valor warranty.