Install Electrical Wiring (If Necessary) - Valor H6 Series Installation And Owner's Manual

QUALIFIED
INSTALLER

Install Electrical Wiring (if necessary)

(for optional fan or power adapter kit)
This section provides information to install the electric
pre-wiring required for use with the 1195CFK Circulat-
ing Fan Kit or GV60PAK Power Adapter Kit.
All wiring must be done by a qualifi ed electrician in
accordance with local codes or, in the absence of
local codes, with the National Electrical Code, ANSI/
NFPA 70 or the Canadian Electrical Code, CSA C22.1.
Electrical Requirements
1195CFK—120 V, 60 Hz, less than 1 amp
General Requirements
The optional 1195CFK kit includes a three-prong
grounded plug to plug into a grounded receptacle, also
included with the kit, to be installed within the fi replace
enclosure by a qualifi ed electrician.
Installation
Thread the power supply cable through the cable
clamp (not provided) and through the hole in the lower
left hand side of the fi replace casing. Do not tighten
the clamp yet. There is a junction box and receptacle
included as part of the 1195CFK fan kit. Refer to
installation instructions packed with kit. A speed control
is also packed with the kit.
If simply roughing in power at this point, ensure
wiring is not live or terminate at this location in a
temporary metal junction box using wire nuts to
cap wires.
Electrical wiring
through the left
hand side of the
appliance case
50
Installation