Replacing Batteries; Using Handset Wall Holder - Valor H6 Series Installation And Owner's Manual

OWNER'S
INFORMATION

Replacing Batteries

WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit.
Low batteries signal: see page 13.
BEFORE changing the batteries, turn the fi replace
off (including pilot).
The appliance uses four 1.5 V AA alkaline batteries
located next to the wall switch and one 9 V alkaline
battery in its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off -season will extend the battery life.
To replace the batteries:
The battery compartment is located next to the wall
switch in the vicinity of the fi replace. Its front plate is
attached with magnets to the wall switch box.
Fireplace
The battery holder is located beside
the wall switch.
18
Servicing & Maintenance
1. Pull on the plate next to the wall switch to access
the batteries.
2. Disconnect the snap connector from the battery
holder. Do not pull the connector by the wire!
3. Replace the batteries with 4 AA alkaline batteries
orienting them as indicated inside the holder.
4. Reconnect the snap connector to the battery holder.
5. Put the battery holder back in its place beside the
wall switch and snap it in place.
Battery
holder

Using Handset Wall Holder

& wall
switch
Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further on
in this manual for the installation.
Disconnect
connector