Valor H6 Series Installation And Owner's Manual page 64

QUALIFIED
INSTALLER
8. Mount switch plate to junction box with 2 long
screws provided. Note: switch position left or right
to suit homeowner wishes.
9. Locate and secure magnet plate using 2 'long'
screws provided
10. Place and secure cover plate to box using 4 screws
provided
11. Feed cable tie through the 2 side slots of battery
cover assembly.
64
Installation
12. Position battery holder to rear face and secure to-
gether with cable tie. note clearance is required for
battery snap connection.
Cable tie
13. Make the snap connection, load 4 AA alkaline bat-
teries into holder (included with fi replace) then feed
back into junction box assembly.
Note: Do not put batteries in the receiver, only
in the battery holder by the wall switch.
14. Test the operation of the wall switch—see page
12.
Side slot
Snap connector
Rear view
Front view