Operating Your Fireplace; Fireplace Control Devices - Valor 1400MN Owner's Manual

Direct vent gas fireplaces
Hide thumbs Also See for 1400MN:
Table of Contents

Advertisement

Operating your fireplace

Fireplace control devices

There are two ways to control your fireplace.
1. Thermostatic Remote Control turns fi re and
lights ON and OFF, controls fl ame height and can
be programmed to function automatically.
2. Wall Switch turns fi re ON and OFF, and controls
fl ame height.
Remote Control
Turn your fi replace ON
 WARNING
STOP IF YOU SMELL GAS! DO NOT LIGHT!
See cover page immediately!
Press and hold:
-
button on remote, or
- ON-OFF button on wall switch
until 8 short beeps confirm the start sequence has
begun; release button.
The pilot lights up, followed by the fireplace.
If you are using the handset, it displays a pilot flame
symbol (
) during the ignition sequence.
If you need to light up the pilot manually, see the
Fireplace and Lighting Information card attached to
the fireplace - see page 7 to learn how to access it.
Also, a copy of this card is reproduced in Appendix A
of the Installation Manual.
Wall Switch
Turn your fi replace OFF (including pilot)
Press and hold:
-
button on remote, or
- ON-OFF button on wall switch
If the flames or pilot are on, they will go out and you
will hear the valve motor wind down. You will hear
a clunk and a beep indicating that the valve has
received the signal from the remote control.
In the unlikely event that you cannot turn off your
fireplace with the remote control handset, use the
wall switch. If the wall switch malfunctions and
will not turn off the fireplace, wait 3 hours and the
fireplace will automatically go to pilot. You can then
access the controls inside your fireplace, once it has
cooled.
 WARNING
Risk of severe burns! Surface of the
fi replace are very hot during operation!
Ensure fi replace has cooled off before
accessing control.
Alternatively, you may turn off the house gas supply.
In all cases, call your dealer for service assistance.
ON:
parallel
to pipe
To use additional functions of your Remote
Control such as temperature or program
settings, see Appendix A—Remote control
operation on page 28 of this manual or visit
valorfireplaces.com/remotes
OFF:
perpendicular
to pipe
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

H61400mp

Table of Contents