Valor H6 Series Installation And Owner's Manual page 10

OWNER'S
INFORMATION
Circulating Fan Operation
(if equipped)
Circulating fan has 4 speed levels from
low to high (1 to 4 bars).
Press SET to scroll to
level icons ash.
To set speed, press ame buttons:
= increases speed.
= decreases speed and
turns OFF fan when all bars disappear.
Note: 8 seconds after the fan is set, handset goes
automatically in temperature control mode. Fan
starts 4 minutes after gas opens (from OFF or
pilot) at maximum speed then goes to displayed
level after 10 seconds. Fan stops 10 minutes after
gas is OFF or at pilot.
Setting ON / OFF Temperatures
Setting "DAYTIME" temperature.
Default Settings:
TEMP
Press SET to scroll to
Hold SET button until TEMP ashes.
To set Daytime Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
Setting "NIGHT TIME SETBACK" temperature.
Default Settings:
T E M P
Press SET to scroll to
T E M P
Hold SET button until TEMP ashes.
To set Night Time Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
10
Using the Remote Control
. Fan and
23 °C/74 °F
TEMP
"--" (OFF)
Setting Program Timers
You can program two periods of time between 12 am
and 11:50 pm in each 24-hour cycle.
Programs P1 and P2 must be set in the following order
during a 24-hour cycle:
P1
= beginning of program period, turns ON
= end of program period, turns OFF
Default Settings:
Program 1: 06:00 am
P1
Program 2: 11:50 pm
P2
Press SET to scroll to
TIMER
If =
P1 P1
programming is cancelled.
To keep replace ON all night, set
11:50 am and
P1
If you want to program only one period,
program
P1
then and
P2
as .
P1
Setting P1 ON time.
Hold SET button until
P1
ashes.
To set ON time:
= hour
= minutes
Press or wait to complete setting.
Setting P1 OFF time.
Hold SET button until
P1
and time ashes.
To set ON time:
= hour
= minutes
Press or wait to complete setting.
, , and
P1
P2 P2
08:00 am
P1
11:50 pm
P2
.
or = ,
P2 P2
at
P2
at 12:00 am.
and with desired times
P1
with the same time
P2
is displayed and time
is displayed
.