Table of Contents
Advertisement
Installation
Refi t and Check Window
1. Place the window in its bottom railing. Ensure to
remove any vermiculite or glass particles in the rail-
ing before installing the window.
Bottom railing
2. Push the top of
the window
frame against
the fi rebox.
3. While you hold it, pull and hook the side levers back
to the window brackets on each side.
4. Pull out top of window to ensure spring loaded
levers work properly.
5. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
Window Re-Installation & Checking
Window frame
Section Views
WARNING
The window unit must be correctly
installed, fastened and sealed after
servicing or serious bodily injury and/or
damage to the appliance may result.
To ensure a safe operation:
• Double-check that the bottom of the
window frame is correctly installed in the
bottom support railing;
• Verify that the levers are hooked properly
to the window tabs then;
• Pull out the top of the window and release
it to insure the springs return it;
• Ensure the window is sealed before
operation.
WARNING
Failure to install the window correctly can:
• Leak carbon monoxide.
• Affect the performance of the fireplace.
• Damage components.
• Cause overheating resulting in dangerous
conditions.
Damage caused by incorrect window
installation is not covered by the Valor
Warranty.
6. If the Hot Glass Warning plate has been removed
from the front lower corner of the window, re-
install it by sliding it between the glass and the
frame as indicated.
Hot Glass Warning Plate
53
Advertisement
Table of Contents
