Replacing Batteries - Valor 1400MN Owner's Manual

Replacing batteries

WARNING
Do not attempt to access the batteries
while the fi replace is hot! Let the
fi replace cool fi rst before touching it!
Caution
Do not use a screwdriver or other metallic
object to remove the batteries from the battery
holder or the handset! This could cause a short
circuit.
Low batteries signals:
• Handset: battery icon on display shows 1 lit bar
• Holder: frequent beeps for 3 seconds when valve
motor turns.
BEFORE changing the batteries, turn the fireplace off
(including pilot) and let it cool.
The fireplace uses four 1.5 V AA alkaline batteries
in a separate battery holder located next to the
wall switch and two 1.5V AAA alkaline battery in its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the
off-season will extend the battery life.
To access the battery holder, remove the magnetic
cover on the remote wall switch by pulling on it; the
battery holder is attached to it.
Fireplace
Receiver Gas valve
Receiver and gas valve located on bottom of fi replace
under removable panel. Battery holder located next to
wall switch.
To replace the batteries:
1. Remove the used batteries from the battery
2. Reinsert the battery holder in the wall switch box
Do not put batteries in the receiver as leaking
acid could damage its circuit board.
Using Handset Wall Holder
Your fireplace equipment includes a wall holder to
store the handset. If it hasn't been installed, refer to
the instructions in the fireplace Installation Manual.
Battery
holder
& wall
switch
holder and replace with 4 new AA 1.5V alkaline
batteries. Do not mix old and new batteries!
snapping the magnetic cover in place.
Caution
Remote and wall holder
11