Replacing Batteries - Valor G3 739 Owner's Manual

Replacing batteries

WARNING
Do not attempt to access the batteries
while the fi replace is hot! Let the
fi replace cool fi rst before touching it!
Caution
Do not use a screwdriver or other metallic
object to remove the batteries from the
battery holder or the handset! This could
cause a short circuit.
Low battery signals:
• Handset: battery icon on display displays one lit bar.
• Receiver: rapid series of beeps during use and op-
eration.
BEFORE changing the batteries, turn the fi replace off
(including pilot) and let it cool.
The fi replace uses four AA 1.5 V alkaline batteries in a
separate battery holder located behind the fi replace
fret or bottom access door. The handset requires one
9V alkaline battery. Batteries should last one to two
seasons, depending on usage. Removing the batteries
during the off -season will extend battery life.
Should the batteries lose power, the control may be
operated by manually turning the control knob at the
valve or by turning off the valve at the power switch.
The battery holder is located under the fi rebox,
behind the fret or bottom access panel.
Battery holder
To replace the batteries in the battery holder:
1. Unhook the barrier screen.
2. Unhook the fret or open bottom access panel. The
battery holder is at right or left of the gas valve.
3. Locate the battery holder and pull it out from its
location.
4. Disconnect it from its cable. Do not pull on the
wire!.
5. Replace the batteries with 4 AA 1.5V alkaline bat-
teries.
Caution
Do not put batteries in the receiver as leaking
acid could damage its circuit board.
6. Reconnect the cable to battery holder.
7. Put the battery holder back in its position.
8. Reinstall the fret or close the access panel and
hook the barrier screen.
Using Handset Wall Holder
Your fi replace equipment includes a wall holder to
store the handset. If it hasn't been installed, refer to
the instructions in the fi replace's Installation Manual.
Handset and Wall Holder
11