Replacing Batteries - Valor 650JN Homeowner's Manual

Replacing batteries

WARNING
Do not attempt to access the batteries
while the fi replace is hot! Let the
fi replace cool fi rst before touching it!
Caution
Do not use a screwdriver or other metallic
object to remove the batteries from the battery
holder or the handset! This could cause a short
circuit.
Low batteries signals:
• Handset: battery icon on display shows 1 lit bar
• Holder: frequent beeps for 3 seconds when valve
motor turns.
BEFORE changing the batteries, turn the fi replace off
(including pilot) and let it cool.
The fi replace uses four 1.5 V AA alkaline batteries in
a separate battery holder located next to the receiver
under the fi rebox and one 9V alkaline battery in its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the
off -season will extend the battery life.
To access the battery holder, unhook the inner front
with barrier screen. Locate the battery holder under
the fi rebox.
Fireplace
Gas Battery
valve holder
Battery holder located next to receiver on
bottom of fi replace behind surround trim
Receiver
To replace the batteries:
1. Unhook the inner front with barrier screen.
2. Locate the battery holder near the receiver and
gas valve. Pull the battery holder out.
3. Disconnect the battery holder wire. Do not pull
on the wire!
Battery holder
4. Remove the used batteries from the battery
holder and replace with 4 new AA 1.5V alkaline
batteries. Do not mix new and used batteries.
Caution
Do not put batteries in the receiver as leaking
acid could damage its circuit board.
5. Reconnect the battery holder wire.
6. Reinstall the battery holder beside the receiver..
Using Handset Wall Holder
Your fi replace equipment includes a wall holder to
store the handset. If it hasn't been installed, refer to
the instructions in the fi replace Installation Manual.
Remote and wall holder
11