Configuring Wireless I/O - Honeywell ControlEdge 900R04-0200 Getting Started

Configuring Wireless I/O

ControlEdge 2020 Controller supports wireless I/O configuration
enabling the user to design, configure, commission and monitor
ISA100 wireless networks and associated wireless field devices by
ControlEdge Builder.
FDAP
node that acts as an ISA100.11a access point and a mesh node
member. FDAP can only communicate through ISA100.11a.
Field Device
input or output channels for process control data.
Wireless I/O Device
Channel
field devices.
Provision
Commission
enabling over-the-air provisioning, associating field devices to the
controller, configuring field device channels and so on.
The following table list the wireless I/O configuration procedure.
Table 6-5: Wireless I/O Configuration procedure
Task
Wireless I/O device configuration - offline
Step 1 Set the controller time.
Step 2 Enable Wireless I/O
protocol on one of the
Ethernet port of the
controller.
: Field Device Access Point (FDAP) is a wireless infrastructure
: A field instrument with no routing capability, provides
: A logical instance of a wireless field device.
: A logical instance that presents the real value acquired from
: Associating field devices to the controller.
: Configuration for FDAP and field device, including
ATTENTION: For wireless I/O, you must use time source as a
precision NTP server.
Go to
l
l
See "Configuring the ISA100 wireless network" >
"Configuring Ethernet port" in the ControlEdge
Builder User's Guide.
See "Setting time source" on page 69 for
more information.
If the NTP server is not available, see "Set_
RTC" in the Function and Function Block
Configuration Reference Guide to
configure the controller time.
Chapter 6 - Communication
111