Configuring Hardware; Setting Controller Name; Configuring The Controller Ip Address - Honeywell ControlEdge 900R04-0200 Getting Started

Chapter 4 - Software

Configuring hardware

Table 4-1: Factory default network settings of the non-redundant controller
Port Default setting
ETH1 IP address is dynamically assigned from a DHCP server.
If no DHCP server is found by the controller, an IPv4 link-local address will be
assigned (169.254.x.x).
ETH2 Static IP address: 192.168.1.50
Table 4-2: Factory default network settings of the redundant controller
Port Default setting
ETH1 IP address is dynamically assigned from a DHCP server.
If no DHCP server is found by the controller, an IPv4 link-local address will be
assigned (169.254.x.x).
The secondary controller IP address is incremented by 1 from the primary
controller IP address.
ETH2 The primary controller static IP address: 192.168.1.50
44

Setting controller name

You can set a new name for a controller.
1. From the Home Page, under
.
Controller Name
2. Enter the desired name for the controller, and click
If using Experion integration with ControlEdge 900 or 2020
controller, this name is used to identify the controller during Experion
configuration.

Configuring the controller IP address

The first thing you will normally want to do is set the IP address for
the controller. The following steps describe how to configure a fixed
IP address starting with creating a new project.
The following table lists the factory default network settings. If your
controller has been previously configured, these settings may have
been changed.
Controller and Programming
, click
Set
.
Save