Honeywell ControlEdge 900R04-0200 Getting Started page 74

Chapter 5 - Operating
74
the upgrade process.
If you do not select the Interactive mode , the firmware will be
l
upgraded directly after the transfer. The controller will be
stopped without any prompt.
4. Click
Proceed with Upgrade
5. From the
Release Number
target firmware version is displayed.
6. Click . The target firmware name, state and version are
Next
displayed.
7. Click to transfer and upgrade the firmware.
Next
8. After the boot firmware is upgraded, enter the password to re-
connect the controller. The application firmware is transferred and
upgraded.
9. After the application has been upgraded, enter the password to re-
connect the controller.
10. The firmware upgrades.
11. Perform the relevant procedures for ControlEdge 2020 controller
and ControlEdge 900 controller.
For ControlEdge 2020 controller:
l
a. Click . The primary CPM synchronizes the firmware with the
OK
secondary CPM, and upgrades the firmware of the secondary
CPM automatically.
b. To check whether the secondary CPM upgrade is complete,
click
Connect
Firmware version
For ControlEdge 900 controller:
l
Upgrading the previous release to R150
l
a. Connect to the secondary CPM (slot B).
b. Repeat Step 1 to Step 10 to upgrade the firmware on the
secondary CPM.
Upgrading R150 to the later release
l
a. Click
OK
the secondary CPM, and upgrades the firmware of the
secondary CPM automatically.
to continue.
list, select the target release module. The
from the Home Page and check that the
is the same as the primary CPM.
. The primary CPM synchronizes the firmware with