Configuring Wireless Inputs - Honeywell Touchpoint Plus Wireless Technical Handbook

MAN0984_Iss 2_09/19
3020M5001_2

7.6.5 Configuring Wireless inputs

Note: You need to complete Network setting for wireless nodes.
To configure full scale of wireless nodes and tags:
1) Login as an Service or higher level
2) Select Menu > Configuration > Channel settings
3) Select required wireless module
4) Select "Wireless Detector" as device type
5) Select a detector and choose "Select"
6) Set full scales and tags
To configure a Wind sensor (if a RAEMet sensor is used)
1) Set Enable or Disable
2) Set Direction to trigger a condition in the chosen range
3) Set Speed to trigger a condition in the chosen setting
4) Set Duration to trigger a condition after the set period
CAUTION – FULL SCALE RANGE
User must set full scale range for every channel.
Trend graph is not available if full scale is not
specified by user.
MODBUS register (30001~30064) data is not
valid if full scale is not specified by user.
Commissioning
64
Touchpoint Plus Wireless
Technical Handbook