Honeywell ControlEdge 900R04-0200 Getting Started page 117

dialog appears.
Management
3. In the left pane, click
page appears.
Configuration
4. Click to add a new network. The
Add New
appears.
5. In the
Network Type
or
Network Honeywell ControlEdge RTU Network
6. Under
IPAddress Configuration
Configure ControlEdge 900 controller
l
To configure a single ControlEdge 900 controller, click
l
and enter the IP address.
IP
To configure dual IP addresses, enter the second IP address
l
in the second text box.
Configure ControlEdge 2020 controller
l
To configure a ControlEdge 2020 controller, click
l
enter the IP address.
To configure multiple ControlEdge 2020 controller nodes
l
simultaneously, click
IP addresses for those devices. From address in the
field and To address in the
7. In the box, default port number is displayed as 5094. If a
Port No
different port number has been set in ControlEdge 900/2020
controller, enter that port number in the box.
8. Click . The specified IP address appears under
Add IP
.
(s)
To change the IP address or to delete the existing IP address, click
Delete IP. The IP address will be deleted under Honeywell
PLC/RTU Configuration and you can enter the new IP address.
9. Type the name of the Remote Communication Interface Server
(RCI Server) in
RCI Server Name
connected to the RCI Server.
By default, FDM populates RCI Server Name with LOCALHOST. If
you do not change this, FDM considers the local host as the RCI
Server.
10. Click .
OK
Network Configurator
drop-down list, click
:
Add IP Range(s)
Add IP Range(s)
box. The configured network is
Chapter 7 - Application
. The
Network
page
Add Network
Honeywell ControlEdge PLC
as required.
Add IP
and enter the range of
Add IP
field.
Configured IP
Add
and
117