Installing Controledge Integration Service - Honeywell ControlEdge 900R04-0200 Getting Started

Installing ControlEdge integration service

Starting with Experion R501.1, you can communicate with the
following controllers in the Experion PKS system through CDA. You
should install and start the ControlEdge integration service on the
Experion Server.
C300
n
ACE
n
Sim-C300
n
Sim-ACE
n
ATTENTION: It is required to install the ControlEdge integration
service on both Experion servers when using Experion Server
redundancy, and all Server nodes in the Experion Backup
Conotrol Center topology.
To install the ControlEdge integration service
1. Insert the
ControlEdge Builder Media Kit
2. Browse to the folder ControlEdgeIntegrationService, and double-
click the file
ControlEdgeIntegrationService.exe
3. The
ControlEdgeIntegrationService - InstallShied
appears. Click Next.
4. In the
License Agreement
and click
agreement
5. In the
Customer Information
required. Click
Next
6. In the
Setup Type
needs. It is recommended to select
7. In the
Ready to Install the Program
installation. You can click
8. The installation is in progress, and then the
appears.
9. Enter the
Username
account that the ControlEdge Integration Service shall log on as.
Click .
OK
page, click
I accept the terms in the license
.
Next
page, enter your information if
.
page, select the setup type that best suits your
Complete
page, click
to abort the installation.
Cancel
, and
Password Confirm password
Chapter 6 - Communication
into the DVD-ROM drive.
.
Wizard dialog
. Click .
Next
to begin the
Install
Set Service Login
for the user
dialog
107