Wireless Connectivity; Connectivity Frequency Range; General Information - Honeywell ComfortPoint Open CPO-PC400-W Manual

WIRELESS CONNECTIVITY

Connectivity Frequency Range

Table 26. Connectivity Frequency Range
Connectivity Frequency
Medium Range
2400 MHz-
Bluetooth
2483.5 MHz
2400 MHz-
Wi-Fi 2.4G
2483.5 MHz
5150 MHz-
5250 MHz
5250 MHz-
5350 MHz
Wi-Fi 5G
5470 MHz-
5725 MHz
5725 MHz-
5850 MHz

General Information

• The WLAN function for this device is restricted to indoor
use only when operating in the 5150 to 5350Mhz
Frequency range. Restrictions or Requirements in
• EMF Statement: To maintain compliance with the RF
exposure requirement, a separation distance of 20 cm
between the device and the human should be
maintained.
• Alarm information in France
— Déclaration d'exposition Attention: Cet émetteur
doit être installé pour fournir une distance de sépa-
ration d'au moins 20 cm de toute personne.
— Le present appareil est conforme aux CNR d'Indus-
trie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisee aux
deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appar-
eil doit accepter tout brouillage radioelectrique
subi, meme si le brouillage est susceptible d'en
compromettre le fonctionnement.
• FCC Warning Statement: "This device complies with Part
15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
• Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
E.I.R.P for E.I.R.P for
CE FCC/IC
20 mW 20 mW
100 mW 320 mW
200 mW 100 mW
200 mW 200 mW
200 mW 200 mW
25 mW 100 mW
15
CPO-PC400-W/CPO-PC400-UW HVAC CONTROLLER
• This device complies with FCC radiation
exposure limits set forth for an uncontrolled
environment.
• This device must not be co-located or operating
in conjunction with any other antenna or
transmitter.
• End users must follow the specific operating
instructions for satisfying RF exposure
compliance.
• FCC Class B Statement: NOTE: This equipment has been
tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
• Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
• IC Statement: This device complies with Industry
Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device.
EN0B-0085 IE10 R0420