Table of Contents
Advertisement
Chapter 4 - Software
48
2.
Click
Onboard I/O
and
.
PI
3.
Select the corresponding channel, and configure parameters.
To add and configure an expansion I/O module
1.
From the Home Page, under
.
Configure I/O
2.
Click
Add I/O Module
dialog appears.
Module
3.
Enter the
Description
which must be same as the rotary switch setting of the physical
device. The range of the address is from one to nine.
4.
Click
to add the I/O module.
OK
5.
Click the corresponding expansion I/O module to view channels.
6.
Select the corresponding channel, and configure parameters.
To add and configure an third-party I/O, ST103A
1.
From the Home Page, under
Configure Third-Party I/O
2.
Click
Add ST103A Module
3.
Enter
Description
identifier for binding with specific meter runs.
4.
Select
for the drop-down list. The valid value is from 1 to
Slave ID
15.
The ST103A should be opened to set Slave ID and row 4 bit
switches will be available to configure the value from 1 to 15. See
"Configuring ST103A" in the ControlEdge 2020 Platform Hardware
Planning and Installation Guide for how to set Slave ID.
ATTENTION: If there are other Modbus devices connected to
the same RS485 port along with ST103A, ensure that they
do not conflict with each other.
5.
Select the port number, and provide values for
6.
Click
to add ST103A module.
OK
7.
Click the corresponding module to view channels.
Only ST103A's analog input, pulse input, frequency and raw pulse
and you can view the five channels
I/O and Communications
>
SC-UMIX01 Mixed I/O Module, 28
and select the
Address
I/O and Communications
>
.
ST103A
. The
Add I/O Module
for ST103A module which will be a unique
,
,
,
AI
AO
DI
DO
and click
, the
Add I/O
for the I/O module
, click
dialog appears.
and
Retries
Timeout
.
Hide quick links:
Advertisement
Table of Contents
