Downloading A Project To The Controller - Honeywell ControlEdge 900R04-0200 Getting Started

Chapter 5 - Operating

Downloading a project to the controller

68
configuration, and upgrading the firmware for over ten
minutes.
After compiling a project without any error, you have to download the
project to the controller.
Before downloading the project to the controller, you have to ensure:
The project is opened in ControlEdge Builder.
n
The project is compiled without any error. See "Compiling a
n
project" on page 65 for more information.
Log in as the Administrator or Engineer to connect the target
n
controller. See "Connecting a controller" on the previous page for
more information.
The primary CPM is connected if the controller is redundant.
n
See "Connecting a controller" on the previous page for more
n
information.
To download a project
1. From the Home Page, click
For more information about the items in the
the embedded online help. Select
PLC state machine
2. A Download confirmation dialog appears to make sure you want
to download. Click
ATTENTION: If you want to upload this project in the future,
you should select
of the archived project will be stored in the controller.
3. There are two scenarios:
If the controller does not contain any project or the project you
l
are going to download has a different name with the project is
already stored in the controller, you should click
window to stop the program execution. Then click
eclrRes
in the
Download
If the project with the same name is already stored in the
l
. A
Download
Help
to display the corresponding content.
.
Yes
Download the project archive
window to continue the download.
eclrRes
window appears:
eclrRes
window, see
eclrRes
> , and search for
Contents
, and a zip file
in the
Stop