Upgrading Serial Module Firmware - Honeywell ControlEdge 900R04-0200 Getting Started

and the controller is stopped. You can also click
the upgrade process.
If you do not select the Interactive mode , the firmware will be
l
upgraded directly after the transfer. The controller will be
stopped without any prompt.
5. Click
Proceed with Upgrade
6. From the
Release Number
target firmware version is displayed.
7. Click , the target firmware name, state and version are
Next
displayed.
8. Click to transfer and upgrade the firmware.
Next
9. After the upgrade is completed, a dialog appears. You can check
which module is upgraded successfully, which one is failed.
10. Click .
OK

Upgrading serial module firmware

Serial module firmware upgrade is ONLY allowed in
or
Running Stopped
ATTENTION: The target serial module must be added in the
Configure Serial Modules page. See "Configuring serial
modules" on page 49 for more information.
To upgrade serial modules
1. From the Start Page, click
2. From the Home Page, select
The
Upgrade Firmware
3. Click the
Serial Comm
displayed.
4. Select or multiselect the target serial modules and click
The
Upgrade firmware
The controller is keeping running when you transfer the firmware
to the controller, and will be stopped when you upgrade the
firmware. So when the controller is running, we provide the
interactive mode to control when the controller stops.
to continue.
list, select the target release module. The
operating modes.
to connect the target controller.
Connect
Upgrade Firmware
dialog appears.
tab, all available serial modules are
dialog appears.
Chapter 5 - Operating
to quit
Cancel
,
Stop Locked
under ,
Maintenance
.
Upgrade
77