Honeywell ControlEdge 900R04-0200 Getting Started page 105

For more information about the function block, right-click it and
select
Help on FB/FU
5. Double-click the pin-outs of the function block to assign variables.
The
Variable Properties
6. Select the
Name
For the parameter
l
GEN_DEV_STATUS
For the parameter
l
from the
DEV_INFO
7. Assign Initial value and I/O address details.
For the parameter
l
field. For example, if the target module name is
Initial Value
"Expansion I/O 01", enter "01".
For the parameter
l
field.
Initial Value
8. Click . The workplace will appear as shown below.
OK
9. Click from the toolbar to compile the programs.
Make
10. Click
Download
programs of HART to the controller.
to display the embedded help.
dialog appears.
, and
Data Type Usage
GEN_DEV_STATUS
from the
Data Type
, you should select
DEV_INFO
list.
Data Type
, enter the target module number in the
IOM
, enter the target channel number in the
CHN
from the toolbar to download the compiled
Chapter 6 - Communication
from the list.
, you should select
list.
HART_CMD48_
HAR_
105