Configuring A Cda Responder - Honeywell ControlEdge 900R04-0200 Getting Started

Chapter 6 - Communication
108
ATTENTION: The user name must be started with "
user should have a "Security level" of at least "Engineer" in
the Experion server. See "Configuring system security" in the
Experion Server and Client Configuration Guide for more
information.
10. The
InstallShield Wizard Completed
To check the status of the ControlEdge integration service
1. Click
Start button
The dialog appears.
Services
2. Find
Honeywell ControlEdge Integration Service
. If it is not, right-click the service and click
Running
3. Check the
Startup Type
service and select
drop-down list.
Startup type

Configuring a CDA Responder

A new project is created and a controller is added to the project in
ControlEdge Builder. See "Creating a project" and "Connecting a
controller" in ControlEdge Builder User's Guide for more details.
To set a controller as a CDA responder
1. From the Home Page, click
or .
ETH1 ETH2
2. Under
Network Setting
the details in the
TIP: The IP addresses for the controller and Experion
devices to be communicated must be on the same subnet.
3. Under
Protocol Binding
responder to the Ethernet port.
4. Click to save the configuration, and click
Save
Home Page.
5. Select CDA from the global variables or local variables you want to
publish to Experion.
dialog appears, click
of PC, and enter
services.msc
is . If it is not, right-click the
Automatic
, and then select
Properties
Configure Ethernet Ports
, select
Use the following IP address
,
IP Address Subnet Mask
, select
CDA Responder
". The
.\
Finish
in the search bar.
, check the
Status
.
Start
from the
Automatic
and select
and enter
and fields.
Gateway
to bind CDA
to return to the
Back
.
is