Configuring Fdm For Controledge Plc/Rtu Network - Honeywell ControlEdge 900R04-0200 Getting Started

Chapter 7 - Application
116
For more information about the different licensing options, see
"Updating the FDM license" in the FDM User's Guide.
Prerequisites
FDM license file
n
FDM Server is in Stop mode
n
To update the FDM license
1. In the
FDM Server Management
2. Under
Upgrade license
license file is stored and choose the file.
3. Click in the
Open
message appears.
4. Click . The path for the license file with the
OK
appears and the license information is updated and appears under
Licensing Information
5. Verify that the
Licensing Information
Server Management Tool.

Configuring FDM for ControlEdge PLC/RTU network

ControlEdge 900/2020 controllers and connected devices are
supported by FDM via the creation of the ControlEdge PLC/RTU
Network. Before using FDM with any ControlEdge PLC/RTU
connected device, it is recommended (but not necessary) that the
devices are commissioned first. After commissioning, use the FDM
Server Management tool to configure the network. To configure a
network, specify the IP address range of all connected controllers in
that network. Use the Build Network operation to discover all
controllers and available HART/ISA Wireless devices.
Prerequisites
All PLC/RTU connected devices are commissioned.
n
Enable the HART-IP interface as applicable in ControlEdge PLC.
n
Enable the HART-IP interface and Wireless I/O as applicable in
n
ControlEdge RTU.
To configure a network
1. On the FDM Server computer, click
>
FDM FDM Server Management Tool
2. Log on to the FDM Server Management Tool. The
dialog box, click the
, click , browse to the folder where the
Select
dialog box. A confirmation
Select a License File
.
is correct before closing the
Start
.
icon.
Licensing
extension
.xml
> >
All Programs Honeywell
FDM Server