Honeywell ControlEdge 900R04-0200 Getting Started page 101

1. Click
Configure Protocols
Ethernet ports which you want to bind.
2. In the
Physical Layer
be the same as the DNP3 master.
3. In the
Data Link Layer
required.
It is recommended to select
select the value in
Maximum value for data link retries is 255 and maximum value for
retry timeout is 3,600,000ms.
If you select
MultiFrag
and
Data Link Retry Timeout
4. In the
Application Layer
as required.
ATTENTION: If you select
here, you cannot enable Primary Server and Secondary
Server under
Miscellaneous
the same time, or else you cannot download your
configuration.
5. In the tab, and select the required mapping table from
Mapping
the drop-down list.
Mapping
If the list is empty, you should add a mapping table first. See
"Adding a DNP3 Slave mapping table" in the ControlEdge Builder
User's Guide.
The same mapping table may be selected for use on multiple
ports. For example, this could be used when a SCADA system
communicates through 2 ports in a redundant arrangement.
6. In the
Default Variation
type of DNP3 point. Default variation defines the data format that
is used by the controller to send data to the DNP3 Master, when
the Master does not ask for a specific data variation.
7. Select or
Flash SD card
.
Events to:
If you want to save DNP3 events to SD card, you must allocate
o
the space for DNP3 events first. See "Preparing SD card" on
page 1 for more information.
> tab and select the target
DNP3 Slave
tab, configure the TCP port number. It should
tab, configure corresponding parameters as
for
Never Data Link Confirmation
and
Data Link Retries
or , ensure that the
Always
are set.
tab, configure corresponding parameters
Enable DNP3 Time Synchronization
>
Configure Date/Time
tab, configure the default variation for each
from the drop-down list besides
Chapter 6 - Communication
Data Link Retry Timeout
Data Link Retries
options at
Save DNP3
and
.
101