Universal Io; Solid State Relay (Ssr); Wireless Connectivity - Honeywell Spyder 7 Installation Instructions Manual

Universal IO

Table 12 Universal IO Specification
Parameter
AO Voltage: 0(2) to 10 VDC direct or
reverse with -3 mA to 20 mA
(Analog
Current: 0(4) to 20 mA
output)
Voltage input: 0(2) to 10 VDC direct or
reverse.
Current input: 0(4) to 20 mA
Sensors: 10k NTC TYPE II, NTC10K3,
10K3A1, 20k NTC, PT100, PT1000,
NI1000 TK5000, Nickel Class B DIN
43760, PT3000, 100 Ohm to 100k
UI
Ohm resistive (custom characteristic).
(Universal
input)
Hardwired wall sensors: Set point, fan
speed, occupancy override.
Dry contact binary input with direct or
reverse voltage.
All UI can be used for pulse input.
Maximum frequency 100 Hz, Minimum
duty cycle (50 % / 50 %) 5 ms ON / 5
ms OFF.
The Spyder Model 7 VAV controller has a single
common terminal for every two UIOs, which protects
them against 24 VAC mis-wiring and short circuits.
Specification
SPYDER MODEL 7 VAV CONTROLLER INSTALLATION INSTRUCTIONS

Solid State Relay (SSR)

Table 13 Solid State Relay (SSR)
Solid state relay switches supply voltage and works
with 24 ± 20% VAC and 41 VDC. VDC switching does
not support synchronous motor.
• 1.5 A constant; 3.5 A inrush for 0.1 sec. per SSR
output
• Optional jumper between 24 VAC supply and SSR
input shared by all SSRs.
• All SSR on the controller must be the same: either all
high side switching or all low side switching.
• Keep the jumper in place for high-side switching.
• Remove the jumper for low side switching.

Wireless Connectivity

Table 14 Connectivity Frequency Range
Parameter
Connectivity
Frequency range
E.I.R.P for CE
(Effective Isotropic
Radiated Power)
E.I.R.P for FCC/IC
(Effective Isotropic
Radiated Power)
7
Specification
Specification
Bluetooth
2400 MHz - 2483.5 MHz
20 mW
20 mW
31-00475-01